PS5081 is 9 port 100Mbps with 8 PoE port switch, auto detection and identification IEEE802.3af standard PD device, then carry power to it. Therefore do not worry it will destroy the private standard PoE or Non-PoE equipment PS5081 is the best choice for mini-type commercial network because it economically use PoE deployment wireless AP and IP camera. PS5081 can resolve the problem of maintenance tedious. wireless coverage, terminal device powered, surveillance project. Maximum save the cost.
- Support power over Ethernet cable device for example wireless AP and IP camera.
- Support IEEE802.3 af standard.
- Data and power transmission distance 100m, it can be flexible installation for wireless AP and surveillance project.
- Support upward port auto MDI/MDIX.
- Adopted storage forward switch system.
- Intelligentized power and minimum consumption, guarantee PD requirement.
- With power supply circuit protection function and protection back-end device safety.
- Automatically provide the adaptive device.
- Adopted single fan radiating increase the device performance.
- PSE modular design
- Support IEEE802.1 Q VLAN and 4K VLANs
- Support loop circuit detection
- Support saving power function when port unconnected
- 8 10/100Mbps PoE RJ45 port (port1 ~ port8)
- 100 Mbps full Duplex, 10 or 100Mbps Half Duplex
- Network interface: 10 BASE-T or 100BASE-TX Ethernet RJ-45
- Bandwidth: 1.8Gbps (no block)
- Network Delay (100 to 100Mbps): maiximum 20 μs（using 64 byte packet)
- MAC address capacity: 1K
- Frames filter and transfer rate:
- 10M port maximum 14,800 pps
- 100M port maximum 148,800pps
|Network protocol and standard
- IEEE802.3i 10BASE-T
- IEEE802.3u 100BASE-TX
- IEEE802.3x Flow Control
- IEEE802.3af/at Power over Ethernet
- Total power 96W (port1~port8), single port max 30W
- Input power: 96W; 52V @ 185A DC output power;(Each country use customized power plug)
- Size (LxHxW): 184mm x 94mm x 27mm
- Operating Temperature: 0°~40°C（32°~113°F）
- Storage Temperature:-20℃~90℃（-4°~194°F）
- Working Humidity: 10%~90% (Non-condensing)
- Storage Temperature: 5%~90% (Non-condensing)
- CE Class B
- FCC Part 15, Class B
- VCCI Class B
||Abnormal and Process
||Red Light ON
||If red light off, please check if the external power supply plug powered normal and the power adaptor connect correctly.
||Green Light ON
||If green light off, please check fi the corresponding RJ45 access network device and the network device and the network cable connect correctly, if the network cable is accord with Cat.5 standard (transmission distance max 100 meter), if the network cable and network.
||PD Device Connection/ Activeness Indication
||LINK: Yellow Light ON ACT: Yellow ON stands for connection normal; Flicker stands for data forward
||If light off, please check if the corresponding RJ45 access network device and POE powered normal, if the network cable connect correctly and network device is damaged.
- In order to safety, please non-professionals don't open the casing of product;
- Please be careful the risk of strong current and security protection when products carry power;
- Please select the right power adaptor provide power for POE switch, before using please confirm if is it accord with the requirement of POE switch;
- Please don't use POE switch under the humid environment, avoiding water go into the product inside caused POE switch breakdown.
- Please start the power after the circuit connected;
- Please don't plug-in and plug-out the connection cable when product is carrying on power;
- Please don't use PoE switch under somewhere with more dust and EME;
- Please don't put heavy thing on POE switch, in order to having an accident;
- According to the IEEE802.3AF standard, please use the Cat.5 or above, transmission distance reach to 100m;
- Please pay attention to don;t exceed the maximum output power of POE switch when it connect more than one PD device;
- Suggestion that PoE switch use for indoor, if you want to use for outdoor, please install waterproof box
Find great products and buy online with E-Market Malaysia. For large quantity, please contact us HERE
Person incharge: KK Leong: +6014 602 8442
Malaysia Toll Free: 1800 87 7061
Kuala Lumpur: +603 2780 3880 / +603 7980 1388
Penang: +604 642 0621
Johor Bahru: +607 361 8927